View Lab Report – E2_Lab_2_8_2_instructor from CSTN WAN at Georgian College. Lab Challenge Static Route Configuration (Instructor Version). View Lab Report – E2_Lab_2_8_2 from ARCHUD 30 at University of California, Los Angeles. Lab Challenge Static Route Configuration Topology. Lab Challenge Static Route. Advanced Static Routing Lab – Router Alley. Lab Configuring Static Routes Ã¢Â€Â“ Instructor Version ·
|Published (Last):||6 August 2009|
|PDF File Size:||20.65 Mb|
|ePub File Size:||9.42 Mb|
|Price:||Free* [*Free Regsitration Required]|
From PC2, is it possible to ping PC1? Subnet the Address Space. Consider the type of static routing that is needed on ISP. Documents Flashcards Grammar checker.
Lab 2.8.2: Challenge Static Route Configuration
Assign appropriate addresses to the device interfaces. List the networks with slash notation. Configure HQ with a default static route. For a review of basic troubleshooting techniques, see Lab 1.
View the routing table of HQ to verify the new static route entries.
You can use any current router in your lab as long as it has the required interfaces as shown in the topology. Assign subnetwork addresses to the Topology Diagram. Configuraion and Activate Serial and Ethernet Addresses. Document the Router Configurations On each router, capture the following command output to a text.
Lab Challenge Static Route Configuration – YouTube – tubemate downloader –
What networks are present in the ISP routing table? Page answwers of 7. Routing and Switching in the Enterprise. Record the command you used. Record the command that you used. However, you can test connectivity between two routers and between and end device and its default gateway. Mr S – Dores Community Website. Answer the following questions to verify that the network is operating as expected: Configure a message-of-the-day banner.
You should dhallenge have connectivity between end devices yet.
Service provider administrators are human, too, and make mistakes. Using the next-hop IP address, configure ISP with a summary static route that includes all of the subnets that are missing from the routing table.
Configure HQ with a static route. You have been given the HQ must be able to send any traffic for which it does not have a route to ISP.
View the routing table of ISP to verify the new static route entry. Configure the router hostname. The summary route will also include the subnet zero route that is reserved for future expansion. Configure ISP with a summary static route. Configure an EXEC mode password.
Lab Challenge Static Route Configuration (Instructor Version)
This document is Cisco Public Information. Consider the type of static routing that is needed on HQ.
How many subnets need to be created from the Synchronize unsolicited messages and debug output with solicited output and prompts for the console and virtual terminal lines. Challenge Static Route Configuration 3. Packet Tracer Skills Integration Challenge.
What networks are present in the HQ routing table? Assign the last valid host address in subnet 3 to Challengs. If any of the above pings failed, check your physical connections and configurations. Disconnect and store the cabling. Consider the following questions when creating snswers network design: Configure a password for VTY connections.
Therefore, it is important that you understand the types of errors an ISP could make that would cause your networks to lose connectivity. Record the command to configure a default static route using the appropriate exit interface. Document the addresses to be used in the table provided under the Topology Diagram.