Post Jobs

IEC 61646 PDF

NATIONAL FOREWORD. The Saudi Standards, Metrology and Quality Organization (SASO) had adopted the IEC “Thin-Film Terrestrial Photovoltaic (PV). IECEE Certification & Testing | IEC Standards | IEC | General Information. PDF | Wet leakage is one of the most frequent failure causes in the IEC test sequences [1]. Although the wet leakage test procedure is.

Author: Mikarn Shaktijas
Country: Antigua & Barbuda
Language: English (Spanish)
Genre: Life
Published (Last): 10 July 2015
Pages: 139
PDF File Size: 17.61 Mb
ePub File Size: 2.26 Mb
ISBN: 320-7-75182-934-6
Downloads: 73712
Price: Free* [*Free Regsitration Required]
Uploader: Voktilar

Certifications IEC < Regulations < News < Coenergia

A special certification for Concentrator PV CPV modules is necessary, because the high concentration of the solar irradiance through lenses or mirrors causes higher iex on the equipment.

An additional test takes the degradation behavior of amorphous silicon due to temperature and irradiance exposure into account. Its purpose and methods. Thank you very much.

This includes all forces of nature:. Photovoltaic PV module safety qualificationwhich was later issued as the European standard EN almost similar. The IEC standard specifies the criteria for the design qualification and type approval of concentrator photovoltaic modules ied assemblies suitable for long-term operation in general open-air climates.


When testing, the prepared and submitted modules undergo HALTs highly accelerated life tests that are not representative of standard real-world conditions. Then only the certification should be ied. Moreover, most certification bodies do not perform regular check ups after the certification has been issued, leaving in theory and praxis many opportunities for bad manufacturers to cut quality corners while on paper holding that certification.

Solar system installers who do installation in areas with heavy snow should definitely use products with an increased load capacity: This has been included in the IEC ed. Nowadays many solar manufacturers produce according this requirement.

Basically, certifications per se do not tell much about the quality of a module. It is crucial to use PV modules tested against salt mist corrosion certification in case the modules shall be installed near coasts or used for maritime applications.

IEC System of Conformity Assessment Schemes

Iecc am a test engineer in SPV lab. Solar installers that are operating in a highly corrosive atmosphere such as near the sea, the resistance of PV panels against the corrosive effects should be checked. Or do I also need IEC ?

The second part consists of 616446 requirements for testing. When I buy a solar panel with IEC certification, does it mean the quality of the solar panel is good? When installing solar panels in areas with heavy snow, an increased load capacity of Pa is advisable.


The certifying authority should conduct the same tests on representative samples after the commercial production has started to confirm the quality on the commercially produced item.

Photovoltaic Solar Testing Specifications

Nevertheless, depending on where 61664 want to install your panels, the certifications may still be required as per your national requirements or for example in order to apply for FIT. Niclas is absolutely correct.

For photovoltaic ie it suggests total insulation, which requires a special insulation of the PV modules according to Safety Class II on the basis of the following requirements:. I have check IEC, but did not find the right information.

IEC tests at the time of applying for certification.