Designation: D − 10Standard Test Method for Energy Measurement for This test method is under the jurisdiction of ASTM Committee D18 on Soil and. Purchase your copy of ASTM D – 16 as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards available. ASTM D ,. “Standard. Test Method for Stress Wave. Energy Measurement for Dynamic. Penetrometer. Testing. Systems”. , speclfles.
|Published (Last):||20 October 2015|
|PDF File Size:||4.65 Mb|
|ePub File Size:||19.90 Mb|
|Price:||Free* [*Free Regsitration Required]|
Read more about SIS Subscriptions.
ASTM D4633 – 16
See also Refs 1- 6. Shopping cart Close cart 0, foreach: Since the measured energy includes the extra potential energy effect due to the set per blow, tests for energy evaluation of the hammer systems should be limited to moderate N-value ranges between atsm and 50 Ref 7.
Subscribe on standards – Read more.
In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs. Soil and Rock I: Link to Active This link will always route to the current Active version of the standard. It is not intended for use with down-hole hammers. In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs.
ASTM D – 16 Standard Test Method for Energy Measurement for Dynamic Penetrometers
Contact us svenska Login. Valid Buy this standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.
The standard is now in your shopping cart. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. When you use our service you can be assured the latest editions and easy access.
Standard Test Method for Energy Measurement for Dynamic Penetrometers
Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method. It is beyond the scope of this standard to consider significant digits used in analytical methods for engineering design. Report error on page. This energy measurement procedure can evaluate variations of N-value resulting from differences in the hammer system.
ASTM D – 16 – Standard Test Method for Energy Measurement for Dynamic Penetrometers
What is a standard? Sustainable Development Goals and standardisation, how do they connect? Atsm to your colleague. The N-value depends on the soil properties but also on the mass, geometry, stroke, anvil, and operating efficiency of the hammer.
The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. The inch-pound units given in parentheses are mathematical conversions which are provided for information purposes only and are not considered standard. These notes and footnotes excluding those in tables and figures shall not be considered as requirements of the standard.
This procedure may also be applicable to other dynamic penetrometer tests. It is not intended for use with down-hole hammers. In addition, they are representative of the significant digits that generally should be retained. Alternatively, the N-value can be used directly in foundation design using correlations to design parameters such as allowable bearing pressure or pile capacity. Your shopping cart is empty. This procedure may also be applicable to other dynamic penetrometer tests.
Subscribe on standards with our subscription service. Please note that the selected d46633 is invalid.